The structural analysis software RFEM 6 is the basis of a modular software system. The main program RFEM 6 is used to define structures, materials, and loads of planar and spatial structural systems consisting of plates, walls, shells, and members. The program also allows you to create combined structures as well as to model solid and contact elements.
RSTAB 9 is a powerful analysis and design software for 3D beam, frame, or truss structure calculations, reflecting the current state of the art and helping structural engineers meet requirements in modern civil engineering.
Do you often spend too long calculating cross-sections? Dlubal Software and the RSECTION stand-alone program facilitate your work by determining section properties of various cross-sections and performing a subsequent stress analysis.
Do you always know where the wind is blowing from? From the direction of innovation, of course! With RWIND 2, you have a program at your side that uses a digital wind tunnel for the numerical simulation of wind flows. The program simulates these flows around any building geometry and determines the wind loads on the surfaces.
Are you looking for an overview of snow load zones, wind zones, and seismic zones? Then you are in the right place. Use the Geo-Zone Tool to determine quickly and efficiently snow loads, wind speeds, and seismic data according to ASCE 7‑16 and other international standards.
Would you like to try out the capabilities of the Dlubal Software programs? You have the opportunity to do so! The free 90-day full version allows you to thoroughly test all our programs.
Based only on the surface results or surface stresses, it is not possible to make a statement about the buckling behavior of the box girder. The stability behavior can be analyzed using the RF‑STABILITY add-on module. It determines the buckling shapes and critical load factors that allow a statement about the buckling behavior.
However, the buckling design has not yet been provided. For this purpose, the buckling shape would have to be transferred to the model, so it can be calculated according to the second-order analysis on the imperfect structural system. A stress analysis with the RF‑STEEL add-on module could then be used to carry out a buckling design.
The RF‑IMP add-on module facilitates the transfer of the buckling shape. Using this module, you can generate the equivalent geometry based on the stability mode so that you can perform a buckling design with a second-order stress analysis on the predeformed structure using RF‑STEEL.
The procedure in RFEM could look like this:
As an alternative, you can use the PLATE-BUCKLING module to analyze the buckling behavior.
There are some very interesting technical articles on this topic on our website.