The structural analysis software RFEM 6 is the basis of a modular software system. The main program RFEM 6 is used to define structures, materials, and loads of planar and spatial structural systems consisting of plates, walls, shells, and members. The program also allows you to create combined structures as well as to model solid and contact elements.
RSTAB 9 is a powerful analysis and design software for 3D beam, frame, or truss structure calculations, reflecting the current state of the art and helping structural engineers meet requirements in modern civil engineering.
Do you often spend too long calculating cross-sections? Dlubal Software and the RSECTION stand-alone program facilitate your work by determining section properties of various cross-sections and performing a subsequent stress analysis.
Do you always know where the wind is blowing from? From the direction of innovation, of course! With RWIND 2, you have a program at your side that uses a digital wind tunnel for the numerical simulation of wind flows. The program simulates these flows around any building geometry and determines the wind loads on the surfaces.
Are you looking for an overview of snow load zones, wind zones, and seismic zones? Then you are in the right place. Use the Geo-Zone Tool to determine quickly and efficiently snow loads, wind speeds, and seismic data according to ASCE 7‑16 and other international standards.
Would you like to try out the capabilities of the Dlubal Software programs? You have the opportunity to do so! The free 90-day full version allows you to thoroughly test all our programs.
In RFEM 6 or RSTAB 9, you can use plastic hinges to simulate the nonlinear behavior of steel structures subjected to a load. You can model a plastic hinge by arranging a hinge with nonlinear properties on a member end. Proceed as follows:
In RFEM, it is possible to determine a pushover curve or a capacity curve and export it to Excel. In the following, you can find a list of the steps that must be performed:
A load distribution similar to the mode shape distribution can be generated automatically with the RF‑DYNAM Pro - Equivalent Loads add-on module. This module determines eigenvalues and equivalent loads based on the response spectrum analysis. For each selected eigenvalue, equivalent loads are generated and exported to RFEM in load cases.
The color display of the plastic hinges is shown in Image 05. You can select the color scale according to the acceptance criteria or according to the defined parameters of the hinge diagram.
A further pushover analysis (determination of the inelastic spectrum, performance point) can then be performed, for example, in Excel.
In the download section below, you can find a detailed description of this tutorial within a PDF document (in English).