RF-CONCRETE Surfaces Version 5

RF-CONCRETE Surfaces Version 5

Switch to Fullscreen Mode Exit Fullscreen Mode

5 Results

Window 2.1 Required Reinforcement Total is displayed immediately after the calculation.

Figure 5.1 Results window

The ultimate limit state designs are listed in the results windows 2.1 through 2.3 according to various criteria.

Windows 3.1 through 3.3 contain the results of the serviceability limit state designs.

You can directly select a window by clicking its entry in the navigator. Use the buttons shown on the left to set the previous or next window. You can also use the function keys [F2 ] and [F3] to go through the windows.

At the bottom of the windows, you find two option buttons. Use these buttons to decide if the results data is shown In FE nodes or In grid points. The results of the FE nodes are determined directly by the analysis core. The grid point results are determined by interpolation of the FE node results.

Click [OK] to save the results. RF-CONCRETE Surfaces closes and you return to the main program.

In the following, the results windows are described in their proper order. Evaluating and checking results is described in chapter 6.