Steel Roofs and Bridge of Sheremetyevo Airport in Moscow, Russia
|Structural Engineering||Structural Analysis & Design
B+G Ingenieure Bollinger und Grohmann GmbH
Frankfurt am Main, Germany
|Construction||Main Contractor for Projecting Roofs and Roofing
Steel Construction for Main Arch
Heinrich Lamparter Stahlbau GmbH & Co. KG
Kassel / Kaufungen, Germany
Steel Construction for Bridge
Müller Offenburg GmbH und Co. KG
Steel Structure Producer
Because of modernization and increased passenger capacity, the third terminal was built at the Sheremetyevo International Airport.
The Dlubal Software customer B+G Ingenieure Bollinger und Grohmann GmbH from Frankfurt am Main, Germany, was responsible under the direction of the Arnold AG for the planning of several projecting roofs and a pedestrian bridge connecting a car park and the terminal.
A special challenge for all companies involved was the three-dimensional planning required to perform the project. Large‑area accumulations of snow had to be taken into account when designing the steel construction. The basic snow load of 26.32 lbf/ft² for Moscow was multiplied with the corresponding factors and resulted in a snow load of 179.62 lbf/ft² to be applied.
The architect's 3D model consisted of a bow (Main Arch) with long span lengths, stretched from the terminal to the parking deck, and a bridge suspended from the arc. Though the bridge got its own arched supporting structure, due to various deformations of single structural components stressed by load, the vertical cables were used additionally.
The Main Arch is an arch structure with supporting cables, starting from the dome-shaped structure in the center of the terminal, running over the main entrance and ending at the car park, creating an entrance hall with span lengths of 184 ft x 141 ft and bridging a distance of 288.7 ft to the parking deck.
The principal supporting structure consists of 4‑chord trusses where cross beams in the form of fish-bellied girders are arranged between them.
It was required that the main arch must have a high flexural resistance because of high eccentric snow loads. The high flexural stiffness, however, resulted in unintentional excessive tensile forces within the bottom chord of the 4‑chord trusses. Therefore, the cables supporting the structure were prestressed with such a high force that the tension forces are overpressed. By prestressing the cables during the assembly, stresses were generated in the upper chord which were reduced only by applying the load of the finishings.
Do you have any questions or need advice?
Contact us or find various suggested solutions and useful tips on our FAQ page.
Program Used for Structural Analysis
The structural engineering software for design of frame, beam and truss structures, performing linear and nonlinear calculations of internal forces, deformations, and support reactions