We provide hints and tips to help you get started with the basic program RFEM.
Invitation to Online Training "Timber Structures Eurocode 5"
Video
First Steps with RFEM
Description
We would like to invite you to our online training "Timber Structures | Eurocode 5."
A reliable internet connection is required to participate. Basic knowledge of RSTAB or RFEM is also expected.
During the training, each participant can ask questions at any time using the chat option.
After the event, each participant will receive the models, video recordings and materials presented in the training for download. This way, the participant can go through and understand the training step by step on the models.
After completing the training, each participant will be awarded a certificate.
Keywords
Event Invitation Online training Timber structures Eurocode 5
Links
- List of Online Training Sessions "Timber Structures | Eurocode 5"
- Timber Structural Analysis and Design Software
Write Comment...
Write Comment...
Contact us
Do you have any questions about our products or need advice on selecting the products needed for your projects?
Contact us via our free e-mail, chat, or forum support or find various suggested solutions and useful tips on our FAQ page.
![[DE] CP 001191 | Diemerstein Valley - Free Form](/-/media/Images/netgenium/thumbnails/2/9/6/6/5/2966566/2966566.png?la=en-US&mw=348&mlid=6C94AB3A02454F7DAD9A460A12CB7058&hash=E83C75041F58152E2A5426F3E8ED0A56C5C3ABEB)
New
Modeling Downstand Beams in Cross-Laminated Timber Constructions with Ribs
This time, we want to look at modeling downstand beams by means of ribs.
The cross-section resistance design analyzes tension and compression along the grain, bending, bending and tension/compression as well as the strength in shear due to shear force.
The design of structural components at risk of buckling or lateral-torsional buckling is performed according to the Equivalent Member Method and considers the systematic axial compression, bending with and without compressive force as well as bending and tension. Deflection of inner spans and cantilevers is compared to the maximal allowable deflection.
Separate design cases allow for a flexible and stability analysis of members, sets of members, and loads.
Design-relevant parameters such as the stability analysis type, member slendernesses, and limit deflections can be freely adjusted.
- How are the signs for the release results of a line release and line hinges interpreted?
- How can I create a curved or arched section?
- Is it possible to design the support pressure or the compression perpendicular to the grain in RX‑TIMBER?
- After the design with RF‑/TIMBER Pro, I optimized a cross-section. Why is the utilization of the optimized cross-section exceeded now?
- Why are the stresses of the 90° orientation not displayed for a layer with the orthotropy direction 90° for σb,90 in RF‑LAMINATE?
- How can I get the member end forces to design the connections?
- I design timber components. The deformations of load combinations deviate from the manual calculation exactly by the factor of the material partial safety factor. Why?
- How can I run the RX‑TIMBER Frame plugin? I did not find it in the Add-on Modules menu nor in Project Navigator - Data.
- I have a question about the results of the serviceability limit state design: How is the increment of the dead load by the factor 1.8 and the imposed load by 1.48 explained in the result combinations for the SLS design?
- Where can I adjust the effective length lef according to Table 6.1 of Eurocode 5 in the TIMBER Pro add-on module?
