526x
002433
2021-03-11

[EN] FAQ 004969 | When performing the fire resistance design with TIMBER Pro, I get the error ...

Question:
When performing the fire resistance design with TIMBER Pro, I get the error 10001. How can I fix the error?

Answer:
If this error message is displayed, the cross-section is obviously not sufficient as there is no remaining cross-section after the specified fire resistance duration. You can check this very easily by reducing the fire resistance duration in the detail settings until the design is still possible. 

In the result of the fire protection design, you can see very well in the graphic how much residual cross-section is still available after the specified fire duration.