Plate and Shell Modeling in RFEM - Part 2
Free Online Seminar
Everything I Expected and More
"RFEM is everything I expected and more. I’m having a blast learning the software and the webinars are fantastic."
Date
Event Language
EnglishContent
- Part 2 of a two-part RFEM webinar series
- Detailed review of model analysis results
- Address surface singularities
- General steel surface stress design
- Consideration of plate buckling behavior
Time Schedule
00:00 | Introduction |
02:32 | Review of tank structure in RFEM from Part 1 |
03:51 | Detailed review of analysis results |
22:30 | Surface stress design in RF-STEEL |
30:08 | Addressing singularities |
44:05 | Linear buckling analysis in RF-STABILITY |
52:30 | Imperfection modeling with RF-IMP |
56:57 | Nonlinear buckling analysis with RF-STABILITY |
01:04:25 | Conclusion |
Speaker

Amy Heilig, PE
CEO - USA Office
Sales & Technical Support Engineer
Amy Heilig is the CEO of the USA office located in Philadelphia, PA. In addition, she provides sales and technical support and continues to aid in the development of Dlubal Software programs for the North American market.
Keywords
Plate Shell Wall Surface FEA Finite element Finite element analysis Industrial Tank Singularity Result Analysis Design Buckling Critical load factor Stress
Write Comment...
Write Comment...
Contact us
Do you have questions related to our webinars? Are you looking for suggestions on which webinar is relevant for your design projects?
Contact us via our free e-mail, chat, or forum support or use our FAQ page.

New
Placing Node Between Two Points
If you wanted to determine the center of a rectangle, it was previously necessary to construct a line from one corner point to the opposite one. By dividing this line, you obtain the centroid. In RFEM 5 and RSTAB 8, you now have the possibility to create a node between two points. Thus, it is sufficient to select the corner points, and then you can determine the distance in absolute or relative values.

- Normal stresses σx from axial force and bending
- Shear stresses τ from shear force and torsion
- Equivalent stresses σv with comparison to limit stress
- Stress ratios related to equivalent stresses
- Normal stress σx from unit normal force N
- Shear stress τ from unit shear forces Vy , Vz , Vu , Vv
- Normal stress σx from unit moments My , Mz Mu , Mv
-
How can I perform a stability/buckling analysis on a load-bearing structure?
- How can I additionally model welds for the connection of two surfaces with a contact solid?
- In connection with the calculation according to the large deformation analysis, I get significantly smaller deformations than for the calculation according to the linear static or second-order analysis. How is this possible?
- How can I deduce the axial stress and hoop stress of a circular container?
- How is it possible to consider the real cross-section geometry of member elements in RWIND Simulation?
- My aim is to mesh a circular hole plate in a mapped way. Is such a meshing possible in RFEM?
- Is it possible to use RFEM for modeling a channel that is distorted from a rectangular cross-section to a pipe cross-section?
- Is it possible to analyze the effects of an hermetically sealed object with RFEM?
- My model should be symmetrical, but the support reactions reflect an unsymmetrical loading or modeling. What can I do?
- I use rotated surfaces in my model. Now it takes a long time to open and edit the file. What can I do about it?