Calculation of Storeys in RFEM 6 Using Building Model Add-On
Free Webinar Information
Everything I Expected and More
"RFEM is everything I expected and more. I’m having a blast learning the software and the webinars are fantastic."
Nicholas J. Greven P.Eng.
07/23/2019
You want more than one storey for your building? Then watch this webinar! You will learn how to design multi-storey structures in the RFEM 6 structural analysis program by means of building models.
Date | Time
Event Language
EnglishTime Schedule
| 0:00 | Introduction |
| 4:02 | Definition of storeys |
| 6:04 | Modeling storeys with rigid planes |
| 11:30 | Results in storeys |
| 15:06 | Design |
Presentation Models to Download
Below, under Models to Download, you will find the models used in the webinar. This will allow you to independently follow the webinar step by step with the provided models.
Speakers
Dipl.-Ing. (FH) Bastian Kuhn, M.Sc.
Product Engineering & Customer Support
Mr. Kuhn is responsible for developing products for timber structures, and provides technical support for our customers.
Dipl.-Ing. (FH) Stefan Frenzel
Product Engineering & Customer Support
Mr. Frenzel is responsible for the development of products for dynamic analysis. He also provides technical support for customers of Dlubal Software.
Keywords
Free Webinar RFEM 6 Surface Multi-layer Laminate Building Model Stiffening Load Center of Mass
Downloads
Links
- Building Model Add-on for RFEM 6
- More About RFEM 6
- More About RSTAB 9
- Add-Ons for RFEM 6 and RSTAB 9
Write Comment...
Write Comment...
Contact Us
Do you have questions about our webinars? Need advice on which webinars are best for your upcoming design project? Contact us via phone, email, chat, or forum or find suggested solutions and useful tips on our FAQ page available 24/7.
New
Modeling and Design of Lap Joint
Modeling and design of a lap joint for a coupled purlin in RFEM 6 and Steel Joints add-on
- I received an error message “Surface of incompatible type... (Surface in upper plane of building story must be of ‘Load transfer’ type)” when running the calculation. What is the reason?
- Can I design members with Class 4 section per CSA S16 in the Steel Design add-on?
- How can I create a contact solid between two surfaces in RFEM?
