"Renumber"> "Single" (see picture 1).In this dialog, you can set the object to be renumbered z. B. "rod sets" a.Then you give a start number before z. B. 101. Care should be taken that this number is not yet assigned to the object to be renumbered. Then you can pi" /> "Renumber"> "Single" (see picture 1).In this dialog, you can set the object to be renumbered z. B. "rod sets" a.Then you give a start number before z. B. 101. Care should be taken that this number is not yet assigned to the object to be renumbered. Then you can pi" /> Is there a way to assign knots, bars, staff sets, load cases etc. to a new number afterwards? | Dlubal Software

Structural Analysis and Design Software

Helpful Questions & Answers

Back to FAQ

Renumber Individually

Figure 01 - Renumber Individually

FAQ 002419 EN-US 02/15/2019

Markus Baumgärtel General RFEM RSTAB

Is there a way to assign knots, bars, staff sets, load cases etc. to a new number afterwards?

Answer

You can find this function in the menu under "Extras"> "Renumber"> "Single" (see picture 1).

In this dialog, you can set the object to be renumbered z. B. "rod sets" a.

Then you give a start number before z. B. 101. Care should be taken that this number is not yet assigned to the object to be renumbered. Then you can pick the individual elements in the graph and change the number.

Keywords

Renumber change numbering

Reference

[1]	Manual RFEM. (2016). Tiefenbach: Dlubal Software.
[2]	Manual RSTAB. (2013). Tiefenbach: Dlubal Software.

Contact us

Contact Dlubal Software

Did you find your question?
If not, contact us via our free e-mail, chat, or forum support, or send us your question via the online form.

Ask Individual Question

info-us@dlubal.com

Was this information helpful?

Associated Products

Display Product Family