- Check to see if the results of the selected load case have been calculated and the support reactions have been activated (see Image 01).
- If this did not work, the settings in the Display navigator probably caused the problem. In this case, we recommend resetting the settings in the Display navigator to the default settings; to do this, first open the Display navigator. Then, right-click the entry in the navigator and open the shortcut menu shown in the graphic below. In the shortcut menu, you can select the "Dlubal Default" entry. Thus, the settings are reset to the default value and the display of support forces should work again.
Question
I would like to graphically display support loads on my screen. Unfortunately, it no longer works, for some reason.
Using the "Beam Panel" thickness type, you can model timber panel elements in 3D space. You just specify the surface geometry and the timber panel elements are generated using an internal member-surface construct, including the simulation of the connection flexibility.
You have the option to perform the fire resistance design of surfaces using the reduced cross-section method. The reduction is applied over the surface thickness. It is possible to perform the design checks for all timber materials allowed for the design.
For cross-laminated timber, depending on the type of adhesive, you can select whether it is possible for individual carbonized layer parts to fall off, and whether you can expect increased charring in certain layer areas.
Among others, the following cross-laminated timber manufacturers are available in the layer structure library:
- Binderholz (USA)
- KLH (USA, CAN)
- Kalesnikoff (USA, CAN)
- Nordic Structures (USA, CAN)
- Mercer Mass Timber
- SmartLam
- Sterling Structural
- Superstructures listed in Lignatec Edition 32 "Cross-Laminated Timber of Swiss Production"
By importing a structure from the layer structure library, all relevant parameters are adopted automatically. The library is continually updated.
The Timber Design add-on for RFEM 6 / RSTAB 9 is multi-purpose and combines a large number of additional elements. [*S16332764*] Timber Design Add-on for RFEM 6