This article was translated by Google Translator View original text

How can I design a reinforced concrete cross-section in SHAPE?

Answer

The reinforced concrete design in SHAPE-THIN has to be activated in the general data. As soon as the design is active, it is possible to set the design accordingly in a separate tab (Figure 01).

There are three types for the design:

Strain-Stress Diagram (Example 01):
An available design ratio is determined by specifying the internal forces

Existing Safety (Example 02):
The state of fracture (ratio = 100%) and; in relation to it; determines a certainty.

Design (Example 03):
By specifying a maximum and minimum diameter or a minimum and a maximum reinforcement, it is possible to increase the reinforcement within the design.

Irrespective of which of the three methods is used, you have to specify the position of the reinforcement and an acting internal force (Figure 02).

Keywords

Design of cross-section Reinforced Concrete Design Arbitrary cross-sections

Downloads

Contact us

Contact Dlubal Software

Did you find your question?
If not, contact us via our free e-mail, chat, or forum support, or send us your question via the online form.

(267) 702-2815

info-us@dlubal.com