In addition to our technical support (e.g. via chat), you’ll find resources on our website that may help you with your design using Dlubal Software.
Frequently Asked Questions (FAQ)
Customer Support 24/7
It depends on the choice of the model type. In this case, a plane system was selected. Thus, the relevant results are displayed even for this plane because they are reduced due to the limited coordinates and degrees of freedom (see Figure 1). However, if you select a 3D structure as the model type, all stresses and internal forces are displayed (see Figure 2).
This depends on the selected settings in the navigator: for the ultimate limit state and the serviceability limit state design, it is possible to select the "limit state" in the Results navigator, whose required reinforcement is to be displayed.
The following settings are possible (see the figure):
- ULS / SLS governing (the envelope of "ULS/SLS")
Did you find your question?
If not, contact us via our free e-mail, chat, or forum support, or send us your question via the online form.
Wind Simulation & Wind Load Generation
With the stand-alone program RWIND Simulation, wind flows around simple or complex structures can be simulated by means of a digital wind tunnel.
The generated wind loads acting on these objects can be imported to RFEM or RSTAB.
“Thank you for the valuable information.
I would like to pay a compliment to your support team. I am always impressed how quickly and professionally the questions are answered. I have used a lot of software with a support contract in the field of structural analysis, but your support is by far the best. ”