In addition to our technical support (e.g. via chat), you’ll find resources on our website that may help you with your design using Dlubal Software.
Frequently Asked Questions (FAQ)
Customer Support 24/7
AnswerThe following causes can be responsible for this:
- In most cases, these differences can be attributed to a lack of convergence. Increasing the iterations and increments in the calculation parameters and FE mesh settings should help.
- High stiffness jumps result in numerical problems, which leads to errors in the result evaluation. In RSTAB, this is not a major problem with a full and analytical approach. In RFEM, on the other hand, approximation approaches are used, so higher stiffness jumps should rather be avoided.
- Bedded bars may well be subject to deviations as well. If the bars are not or only roughly divided, there are convergence problems. A practical solution here is to select a "finer" bar pitch in the FE mesh settings.
Did you find your question?
If not, contact us via our free e-mail, chat, or forum support, or send us your question via the online form.
Wind Simulation & Wind Load Generation
With the stand-alone program RWIND Simulation, wind flows around simple or complex structures can be simulated by means of a digital wind tunnel.
The generated wind loads acting on these objects can be imported to RFEM or RSTAB.
“Thank you very much for the useful information.
I would like to pay a compliment to your support team. I am always impressed how quickly and professionally the questions are answered. In the industry of structural analysis, I use several software including service contract, but your support is by far the best.”