In addition to our technical support (e.g. via chat), you’ll find resources on our website that may help you with your design using Dlubal Software.
Frequently Asked Questions (FAQ)
Customer Support 24/7
You have probably carried out the design in RF‑/TIMBER Pro according to DIN 1052:2008 and used a cut-to-grain angle of less than 3° (see Figure 01). According to Section 10.4.1 (1) of DIN 1052, such a cut-to-grain angle does not need to be considered. If you switch the design to the current DIN EN 1995 (see Figure 02), the design will also be carried out for the angle of less than 3°.
Furthermore, the module allows you to analyze transversal tension stress in the apex etc., according to the Section 6.4.3 ff. of the Eurocode. This procedure is explained in detail in the webinar.
Did you find your question?
If not, contact us via our free e-mail, chat, or forum support, or send us your question via the online form.
Your support is by far the best
“Thank you very much for the useful information.
I would like to pay a compliment to your support team. I am always impressed how quickly and professionally the questions are answered. In the industry of structural analysis, I use several software including service contract, but your support is by far the best.”