Total Displacement of Result Combinations
Tips & Tricks
By means of result combinations, it is possible to create, among others, the envelopes for internal forces and deformations. Thus, the user finds swiftly the maximum and the minimum internal forces for later analysis. However, you should pay special attention to the display of the global deformation ‘u’. This is determined by the following formula:u = √(uX2 + uY2 + uZ2)
The related resulting deformation for load cases and load combinations is displayed accordingly. Together with the result combinations, also the maximum deformation components of the directions are calculated. There comes up a combination of deformations resulting from different load cases that would never occur that way. The result is shown in the lowest three figures. The resulting total displacement of result combinations does not cover the maximum deformation of the load cases to be examined and these deformations do not correspond qualitatively with any of the cases.
Therefore, the total deformation should always be analysed in load cases or load combinations.
Dipl.-Ing. (FH) Lukas Sühnel
Product Engineering & Customer Support
- Automatic Generation of Load Combinations in RFEM
- Automatic Generation of Load Combinations in RSTAB
Do you have questions or need advice?
Contact our free e-mail, chat, or forum support or find various suggested solutions and useful tips on our FAQ page.
Structural engineering software for finite element analysis (FEA) of planar and spatial structural systems consisting of plates, walls, shells, members (beams), solids and contact elements
The structural engineering software for design of frame, beam and truss structures, performing linear and nonlinear calculations of internal forces, deformations, and support reactions