Arrangement of Line Releases Between Surfaces of Different Sizes
Tips & Tricks
In case of a line release placed between two surfaces with one of them hanging over the common connection line, you should pay attention to that when designing line releases.
The reason is, that the line release reduces the stiffness in the first adjacent element row of the related surface corresponding to the selected degrees of freedom. If the line release is placed on a larger surface, then the stiffness of all finite elements involved in the force transmission to a smaller surface is not reduced. The elements affecting the start and end nodes of the lines, but not the line itself, still transfer the forces. This behavior is illustrated in the figure.
The described effect also occurs if there are other elements (for example members) at the start or end point of the line release.
Do you have any questions or need advice?
Contact us or find various suggested solutions and useful tips on our FAQ page.
Structural engineering software for finite element analysis (FEA) of planar and spatial structural systems consisting of plates, walls, shells, members (beams), solids and contact elements
The structural engineering software for design of frame, beam and truss structures, performing linear and nonlinear calculations of internal forces, deformations, and support reactions