Graphical Schema of Required Bending Reinforcement
Tips & Tricks
As of the program version x.06.1103, various optimizations are available. The RF‑/FOUNDATION Pro add‑on module has also been subjected to further development.
One of the new features is the additional representation of graphical schema of the required bending reinforcement for a foundation plate in the printout report. Now the required bending reinforcement is displayed as combined at the top and bottom in the main and secondary load‑bearing direction in a graphic. The location of the design section applied is documented graphically as well.
This schema is available by default when creating a new printout report in the program version x.06.1103. You can select it in the Printout Report Selection, ‘Results 2’ tab. If necessary, you can also disable this schema in the same dialog box.
This graphic is supplemented by a table showing the required bending reinforcement, which is also activated by default.
Do you have questions or need advice?
Contact our free e-mail, chat, or forum support or find various suggested solutions and useful tips on our FAQ page.