RF-CONCRETE Surfaces – Online Manual Version 5

Online manuals, introductory examples, tutorials, and other documentation.

RF-CONCRETE Surfaces – Online Manual Version 5

Switch to Fullscreen Mode Exit Fullscreen Mode

1.3 Opening the RF-CONCRETE Surfaces Add-on Module

RFEM provides the following options to start the RF-CONCRETE Surfaces add-on module.

Menu

To start the add-on module, select the RFEM menu item

Add-on Modules → Design - Concrete → RF-CONCRETE Surfaces.

Figure 1.1 Add-on ModulesDesign - ConcreteRF-CONCRETE Surfaces menu item
Navigator

Alternatively, you can start the add-on module in the Data navigator by selecting

Add-on Modules → RF-CONCRETE Surfaces.

Figure 1.2 Data navigator: Add-on ModulesRF-CONCRETE Surfaces
Panel

If results from RF-CONCRETE Surfaces are already available in the RFEM model, you can also start the design module in the panel:

Set the relevant design case of RF-CONCRETE Surfaces in the load case list of the menu bar. Then, use the [Show Results] button to display the reinforcements graphically.

Now you can click the [RF-CONCRETE Surfaces] button in the panel to open the add-on module.

Figure 1.3 [RF-CONCRETE Surfaces] panel button

Quick Overview of this Section

Quick Overview of this Section