3D Structural & BIM Software

Reinforcement Transfer from RFEM to Autodesk Structural Detailing

Using this interface, it is possible to directly export the results including the geometry from the RF-CONCRETE Surfaces add-on module into AutoCAD Structural Detailing. In addition, vertical and horizontal surfaces can be transferred at the same time.

  1. Direct export to Autodesk Structural Detailing

    Data Export

    The results of the top or bottom reinforcement can be optionally exported in finite element nodes or in grid points. Furthermore, it is possible to define an offset for the entire model.

    The values exported to AutoCAD Structural Detailing are dynamic: The program subtracts the applied amount of reinforcement directly from the required reinforcement. Thus, you can immediately see how much additional reinforcement must be added.

Contact us


Do you have any questions about our products? Do you need advice for your current project? 
Contact us or find various suggested solutions and useful tips on our FAQ page.

+49 9673 9203 0