It facilitates the modelling of surface and member structures. The library can be filtered and extended by user-defined entries. Furthermore, it is possible to import the special sections from the cross-section properties software SHAPE‑THIN and SHAPE‑MASSIVE and use them for the calculation.
In the add-on modules RF-/TIMBER Pro, RF-/TIMBER AWC, and RF-/TIMBER CSA, it is possible to consider the resulting deformation of a member or set of members. In addition to the local directions y and z, you also have the option ‘R’. This allows you to compare the total deflection of a girder to the limit values given in the standards.
Depending on stiffness, mass, and damping, structures react differently to wind action.
- Are the models and presentations from Info Day 2017 freely available, and can you send them to me?
- Are the models and presentations from Info Day 2015 freely available, and can you send them to me?
- How do I display the utilization rate of a compression column in RF-CONCRETE Members?
- Is it possible to use a contact solid or a layered FE mesh for a solid also in the case of curved surfaces? Because I get the error No. 848.
How can I retrospectively reduce the determined provided longitudinal reinforcement in RF‑CONCRETE Columns?
- Why do I get the error message 10203 for a result beam when performing design with RF‑CONCRETE Members?
- I have a model of a timber building, which I have transferred from Scia Engineer and adapted it into the RFEM program. The models should be the same; however, it can only be calculated in Scia Engineer while RFEM reports singularity. How do I edit the model to analyze it in RFEM?
- How can I model a timber-concrete composite floor?
- When calculating a cable using the STEEL EC3 add‑on module, there is the error message "Incorrect characteristic stresses for material No. 1! Please correct this in Table 1.2."
- Is it possible to design a spherically curved glass pane in RF‑GLASS?
Structural engineering software for finite element analysis (FEA) of planar and spatial structural systems consisting of plates, walls, shells, members (beams), solids and contact elements
The structural engineering software for design of frame, beam and truss structures, performing linear and nonlinear calculations of internal forces, deformations, and support reactions