The material model Orthotropic Masonry 2D is an elastoplastic model that additionally allows softening of the material, which can be different in the local x- and y-direction of a surface. The material model is suitable for (unreinforced) masonry walls with in-plane loads.
- Can the properties, such as B. the cross -section or the surface thickness as well as the material of a surface of an existing element for a new element?
- Are the Dlubal Software programs suitable for the analysis and design of hydraulic steel structures?
- When calculating a cable using the STEEL EC3 add‑on module, he error message "Incorrect characteristic stresses for material No. 1! Please correct this in Table 1.2." appears.
Is it possible to specify shrinkage effects as loads?
- Are the effective length coefficients in the add-on modules for the aluminum and steel design automatically determined from the model or do I have to make adjustments?
Which units are specified in the result display of the support reactions (kN or kN/m)? A note about this is missing in the graphic.
In the case that the support reactions are given in kN/m, for which distance does the value apply?
- I design a cross-section created in the SHAPE‑THIN program by using the RF‑STEEL EC3 add-on module, but the program shows the error message "ER006 Invalid type of c/t-part for cross-section of type General." What can I do?
Is it possible to calculate American steel cross-sections?
- Where do I find the setting to specify the entered structural component as a "wall" or "slab"?
- The four plates, identically loaded, show different negative moments at the point of support. Is this a mistake?
Structural engineering software for finite element analysis (FEA) of planar and spatial structural systems consisting of plates, walls, shells, members (beams), solids and contact elements
The structural engineering software for design of frame, beam and truss structures, performing linear and nonlinear calculations of internal forces, deformations, and support reactions