In addition to our technical support (e.g. via chat), you’ll find resources on our website that may help you with your design using Dlubal Software.
Frequently Asked Questions (FAQ)
Customer Support 24/7
AnswerFrom the formulae of EC 3‑1‑8, it is obvious that the ultimate tensile forces of the beam end plate are introduced into the column flange, and thus directly into the column web.
Therefore, the upper end plate is not fully stressed by these forces.
For purely structural reasons, the column head plate is available for stiffening and the buckling panel limit, and in case of the required diagonal stiffener, it is used for the transmission of the proportional force that goes into the stiffener.
The geometry depends on the definition of the structural components. In Window "1.2 Nodes and Members," there is the specification of which member is calculated as a column and which one as a beam. The program always recognizes the column as a continuous structural component by default (see Figure 01).In order to make the beam continuous, simply change the status of the individual members (see Figure 02). The actual beam will have the "Column" status and the actual column will be defined as a "Beam."
Did you find your question?
If not, contact us via our free e-mail, chat, or forum support, or send us your question via the online form.
Wind Simulation & Wind Load Generation
With the stand-alone program RWIND Simulation, wind flows around simple or complex structures can be simulated by means of a digital wind tunnel.
The generated wind loads acting on these objects can be imported to RFEM or RSTAB.
“Thank you for the valuable information.
I would like to pay a compliment to your support team. I am always impressed how quickly and professionally the questions are answered. I have used a lot of software with a support contract in the field of structural analysis, but your support is by far the best. ”