In addition to our technical support (e.g. via chat), you’ll find resources on our website that may help you with your design using Dlubal Software.
Frequently Asked Questions (FAQ)
Customer Support 24/7
AnswerBy default, the graphic is only printed in the report at more than 40% of the page height. In some cases, it may be useful to display the graphic printout over the entire height of the page and to rotate the graphic by 90 ° (see Figure 02). Normally, it should be sufficient to display the dimensions with two decimal places in order to save space. This setting can be defined in the menu "Units and Decimal Places" (see Figure 03). Finally, the auxiliary lines can be shortened and the font size can be reduced (see Figure 04). A font size of 5 should be sufficient for an A4 printout. To select a small font size, you should use the "Small Fonts" font. The finished result is shown in Figure 05.
AnswerYes, the data is freely available. With the following download option you can load the presentations and finished models of the speakers.
To display the color scale, the following settings must be made:
- For bar results: Activate the option "Colored with gradient", "Colored without gradient" or "Cross sections" under "Results" -> "Bars" in the Point Navigator, see Figure 1
- For area results: Activate the options "Isosurfaces", "Isolines" or "Differences" under "Results" -> "Display type", see Figure 1
- For bar and area results: Selection of all or selected bars / areas within the "Filter" tab in the panel, see Figure 2
AnswerThe plastic stresses are output exclusively in the representation type isosurfaces . The display type can be selected via the icon in the toolbar (see Figure 1) or in the Project Navigator - Show under Results -> Display type can be set.
So that the result values of the bearing forces are not displayed one above the other, you can adjust the "display factor" for the bearing forces in the result panel (to the right of the graphics window).
If you enlarge it, the presentation should be better (see Figure 1).
Alternatively, you can also right-click in the graphics window and adjust the "Display Properties". Under the category "Results"> "Storage reactions"> "Nodal forces" you can adjust the size of the representation.
If the input has an effect, you can also adjust the "Relative limit settings" in the detail settings (see Figure 2).
If you only want to display a value "Max" or "Min value" in the EC results, you can set this in the result navigator for the EC results (see Figure 3).
Did you find your question?
If not, contact us via our free e-mail, chat, or forum support, or send us your question via the online form.
Your support is by far the best
“Thank you very much for the useful information.
I would like to pay a compliment to your support team. I am always impressed how quickly and professionally the questions are answered. In the industry of structural analysis, I use several software including service contract, but your support is by far the best.”