In addition to our technical support (e.g. via chat), you’ll find resources on our website that may help you with your design using Dlubal Software.
Frequently Asked Questions (FAQ)
Customer Support 24/7
AnswerYes, you can define an area in the panel by clicking the button "options". Here you can define a customized area by moving the slider. In that case the areas with higher or lower stresses have no color.
AnswerThe panel that appears after the calculation has been performed has a filter for displaying certain elements. Occasionally, elements may be intentionally or unconsciously removed from the results display.
It is therefore recommended that elements in the result display are missing unexpectedly before checking the filter of the panel first (see figure).
AnswerIn the case where the color gamut is placed outside the graph, an additional width default becomes active for that particular case. This applies primarily to the dimen- sions of the scale size on the right side.
AnswerWhen you print a graphic in the printout report in the printout report, it also becomes automaticis displayed in the printout report graphic. The scale display can not be hidden.
To display the color scale, the following settings must be made:
- For bar results: Activate the option "Colored with gradient", "Colored without gradient" or "Cross sections" under "Results" -> "Bars" in the Point Navigator, see Figure 1
- For area results: Activate the options "Isosurfaces", "Isolines" or "Differences" under "Results" -> "Display type", see Figure 1
- For bar and area results: Selection of all or selected bars / areas within the "Filter" tab in the panel, see Figure 2
When displaying member and surface results on the screen at the same time, only one panel appears. However, you can switch between members and surfaces (see Figure 01).
In the case of the graphic printout, you can specify how to display both panels in the printout report (see Figure 02).
AnswerIn order to increase the color scale and the font size in the graphics panel, you can set the size of the color scale and the text in the properties of the respective graphic or graphics print (see Figure 1). If the font is to be enlarged, the height of the color gamut usually has to be adjusted, otherwise the font overlaps the color gamut.
Did you find your question?
If not, contact us via our free e-mail, chat, or forum support, or send us your question via the online form.
Your support is by far the best
“Thank you very much for the useful information.
I would like to pay a compliment to your support team. I am always impressed how quickly and professionally the questions are answered. In the industry of structural analysis, I use several software including service contract, but your support is by far the best.”