In addition to our technical support (e.g. via chat), you’ll find resources on our website that may help you with your design using Dlubal Software.
Frequently Asked Questions (FAQ)
Customer Support 24/7
AnswerFor the design of steel surfaces please use the module of the same name RF-STEEL Surfaces. If you also want to consider local denting, then the additional modules RF-STABIL (to determine the bulge and branching loads) and RF-IMP (to determine the imperfection figure, based on the bulge pattern) are also recommended.
AnswerUnfortunately not. Intermediate supports and nodal supports have to be set manually. The default configuration for effective lengths is 1,0*member length and for set of members, one nodal support with definition u_y' and phi_x' is defined on each side of the set of member.To speed up the process of defining nodal supports, you can pick more nodes in one step by using the highlighted function in the attached picture.
AnswerRF- / STEEL EC3 measures cross-sections of cross-section class 4 using the effective width method according to EN 1993-1-5. The existing voltage is taken into account.
AnswerIf you have edited the cross-section values of a cross-section or the stiffnesses of a bar with the function "Modify stiffnesses", these are not used in the additional module STAHL EC3. The modified stiffnesses are only used in the internal force calculation. Therefore, it is better to work with double bars when using the STAHL EC3 design.
That's right, both add-on modules count on the 7th. Degree of freedom, warping.
The difference is that in RF- / FE-LTB, only the loads acting directly on the set of members are automatically detected. Loads from other structural components that are indirectly effective on the set of the RFEM implementations must be added manually as Extra Loads. In RF- / FE-LTB, a complete recalculation of the structure takes place.
RF- / STEEL Warping Torsion on the other hand analyzes the internal force diagrams from the calculation of the main program and then calculates the loads back. They will be newly applied and calculated. Thus, the input of the loading is omitted, which means a time saving.
AnswerNo, hinges have to be defined separately in the model and cannot be generated automatically by RF-/STEEL EC3.
In Window 2.2 'Member Loads', you can define the eccentricity of the load by scrolling to the right in the table.
By using a button, you can also graphically select the stress points of a cross-section and thus define the eccentricity on the basis of the cross-section (see figure).
Did you find your question?
If not, contact us via our free e-mail, chat, or forum support, or send us your question via the online form.
Your support is by far the best
“Thank you very much for the useful information.
I would like to pay a compliment to your support team. I am always impressed how quickly and professionally the questions are answered. In the industry of structural analysis, I use several software including service contract, but your support is by far the best.”