In addition to our technical support (e.g. via chat), you’ll find resources on our website that may help you with your design using Dlubal Software.
Frequently Asked Questions (FAQ)
Customer Support 24/7
AnswerYou can usually set the standard and the National Annex in the top right corner of an add‑on module (see Figure 01). In most cases, it is also possible to display the factors of the National Annex and edit them, if necessary (see Figure 02).
AnswerThe standard 1993-1-8 specifies, which kind of cross-sections can be considered. The designs are interpreted in such a way, that one wall thickness is only possible for a cross-section. If there is an invalid cross-section, the corresponding message is displayed (see Figure 01). Therefore, the question about the extension for such cross-sections is to be answered in the negative. The standard is largely based on tests / research. Therefore, the focus is on hot finished hollow sections according to EN 10210 and cold formed hollow sections according to EN 10219.
Did you find your question?
If not, contact us via our free e-mail, chat, or forum support, or send us your question via the online form.
Wind Simulation & Wind Load Generation
With the stand-alone program RWIND Simulation, wind flows around simple or complex structures can be simulated by means of a digital wind tunnel.
The generated wind loads acting on these objects can be imported to RFEM or RSTAB.
“Thank you for the valuable information.
I would like to pay a compliment to your support team. I am always impressed how quickly and professionally the questions are answered. I have used a lot of software with a support contract in the field of structural analysis, but your support is by far the best. ”