- More than 45,000 users in 95 countries
- One software package for all application areas
- Free support provided by experienced engineers
- Short learning time and intuitive handling
- Excellent price/performance ratio
- Flexible modular concept, extensible according to your needs
- Scalable license system with single and network licenses
- Proven software used in many well-known projects
Why Dlubal Software?
Wind Simulation & Wind Load Generation
With the stand-alone program RWIND Simulation, wind flows around simple or complex structures can be simulated by means of a digital wind tunnel.
The generated wind loads acting on these objects can be imported to RFEM or RSTAB.
Nonlinear Calculation of a Floor Slab Made of Steel Fiber Reinforced Concrete in the Serviceability Limit State with RFEM
Describing the procedure for the serviceability limit state design of a floor slab made of steel fiber reinforced concrete. This article shows how to perform the corresponding design for the SLS by means of the iteratively determined FEA results.
Nonlinear Calculation of a Floor Slab Made of Steel Fiber Reinforced Concrete in the Ultimate Limit State with RFEM
Steel fiber reinforced concrete is nowadays mainly used for industrial floors or hall floors, for foundation plates with low loads, basement walls and basement floors. Since the publication of the first guideline by the German Committee for Reinforced Concrete (DAfStb) about steel fiber reinforced concrete in 2010, the structural engineer can use standards for the design of the composite material steel fiber reinforced concrete, which makes the use of fiber reinforced concrete increasingly popular in construction. This article describes the nonlinear calculation of a foundation plate made of steel fiber reinforced concrete in the ultimate limit state with the FEA software RFEM.
Steel fiber reinforced concrete is nowadays mainly used for industrial floors or hall floors, for foundation plates with low loads, basement walls and basement floors. Since the publication of the first guideline by the German Committee for Reinforced Concrete (DAfStb) about steel fiber reinforced concrete in 2010, the structural engineer can use standards for the design of the composite material steel fiber reinforced concrete, which makes the use of fiber reinforced concrete increasingly popular in construction. This article explains the individual material parameters of the steel fiber reinforced concrete and how to deal with these material parameters in the FEM program RFEM.
When modeling a reinforced concrete rib with a masonry wall above, there is the risk that the rib is underdesigned if the structural behavior of the masonry is not correctly considered and the connection between masonry wall and downstand beam is not modeled sufficiently accurate. This article deals with this issue and shows possible modeling options of such a structure. In this example, the reinforcement is determined only from the internal forces and without any secondary minimum reinforcement.
Designing End Plate Connection of Hollow Sections Under Tension According to the CIDECT Method and by Means of the FEM Model
A site joint consisting of hollow sections with end plates will be designed. It is the bottom chord of a truss which has to be divided for transport reasons.
The deformations of the FE nodes are always the first result of an FE calculation. Based on these deformations and the stiffness of the elements, it is possible to calculate strains, internal forces, and stresses.
The calculation in RFEM is usually carried out in several calculation steps, the so-called iterations. It is then possible to consider particular characteristics of the model such as objects with nonlinear functions. In addition, by using the iterative calculation, nonlinear effects are taken into account which result from changes in deformation and internal forces in case of the second-order analysis or when considering large deformations (cable theory). In case of complex models, geometric linear calculations are usually not sufficient.
Shell buckling is considered to be the most recent and least explored stability issue of structural engineering. This is less due to a lack of research activities, but rather due to the complexity of the theory. With the introduction and further development of the finite element method in structural engineering practice, some engineers no longer have to deal with the complicated theory of shell buckling. Evidence of the problems and errors to which this gives rise is very well summarized in .
Do you have questions or need advice?
Contact our free e-mail, chat, or forum support or find various suggested solutions and useful tips on our FAQ page.
Customer Support 24/7