I have modelled a precast slab as "orthotropic surface". Can I use these surfaces also in reinforced concrete design?

Risposta

Yes, you can use "orthotropic surfaces" for the reinforced concrete design in RF-CONCRETE Surfaces.

If you only would like to carry out serviceability limit state designs, you do not have to define additional settings in RF-CONCRETE Surfaces concerning the surface type.

You need the RF-CONCRETE NL add-on module to perform the serviceability limit state designs. Select in the "serviceability limit state" tab (in the dialog box "1.1 General Data") the design method "Nonlinear...". See Figure 01.

You can then change the surface type to "Constant" in the dialog box "1.3 Surfaces" so that the serviceability limit state design is also possible here. See Figure 02.

Parole chiave

orthotropy, orthotropic surface, precast slab, precast elements

Contattaci

Contattaci

Hai trovato la risposta alla tua domanda? In caso contrario, contattaci o inviaci la tua domanda utilizzando il modulo online.

+39 051 9525 443

info@dlubal.it

RFEM Strutture in cemento armato
RF-CONCRETE 5.xx

Modulo aggiuntivo

Progettazione delle aste e delle superfici di cemento armato (piastre, pareti, strutture piane, gusci)

Prezzo della prima licenza
810,00 USD
RFEM Strutture in cemento armato
RF-CONCRETE NL 5.xx

Modulo aggiuntivo

Calcolo non-lineare delle strutture intelaiate ed a piastra realizzate in cemento armato

Prezzo della prima licenza
1.300,00 USD