Co oznaczają informacje projektowe: Błąd geometrii po lewej stronie: Blacha czołowa dźwigara: Lambda2>1,4 Półka słupa: Lambda2>1,4 Nie mogę znaleźć żadnego wyjaśnienia w instrukcji ani w Internecie.
Czy posiadają Państwo program do wymiarowania słupów zamocowanych w betonie? Nie chodzi o zaprojektowanie kielicha, ale o wymaganą głębokość osadzenia, przewidziane naprężenie w betonie, kontrolę naprężenia ścinającego w słupie i tak dalej.
Do obliczeń aktywowałem opcję "Obliczenia szczegółowe". Czy obciążenia podporowe ze zredukowanym współczynnikiem dynamicznym zostały już określone do wymiarowania konstrukcji nośnej?
Użyłem podwójnych prętów do wprowadzania prętów. Czy muszę brać pod uwagę coś jeszcze, czy może lepiej wprowadzić pręt o podwójnych właściwościach przekroju?
Muszę zwymiarować wspornik ścienny wykonany ze stalowych wsporników, który zamodelowałem jako komponenty powierzchniowe w programie RFEM 5. Z którego modułu mogę skorzystać?
Chciałbym zaprojektować poręcze, dlatego stworzyłem zestaw prętów. Przekrój jest przekrojem zamkniętym. Czy analizę stateczności można przeprowadzić na całej konstrukcji, czy też muszę przeliczyć ją z danymi wszystkich podpór na wymiarowanie pręta zastępczego w programie STEEL EC3?
Przeprowadzam analizę stateczności zgodnie z analizą drugiego rzędu. Dlaczego do analizy naprężeń wykorzystywany jest tutaj częściowy współczynnik bezpieczeństwa γM1?
Podczas obliczeń otrzymuję ostrzeżenie, że niektóre elementy są połączone z panelem wyboczeniowym, ale nie są zdefiniowane jak usztywnienia (patrz rysunek 01). Co mam zrobić?
Podczas obliczania połączenia za pomocą modułu rozszerzającego FRAME‑JOINT Pro pojawia się komunikat, że wartość jest poza dopuszczalnym zakresem (istniejący Wartość: 160, wartość minimalna 200). Co oznacza ta wiadomość?