Exemplos de verificação

Bending Vibrations with Axial Force

A cantilever of rectangular cross‑section has a mass at its end. Furthermore, it is loaded by an axial force. Calculate the natural frequency of the structure. Neglect the self‑weight of the cantilever and consider the influence of axial force for the stiffness modification.

Influence of the Normal Force on the Torsion

Member with the given boundary conditions is loaded with the moment and the axial force. Neglecting it's self-weight, determine beam's maximum torsional deformation as well as its inner torsional moment defined as a sum of a primary torsional moment and torsional moment caused by the normal force. Provide a comparison of those values while assuming or neglecting the influence of the normal force.

Cantilever Under Torsion Without Warping

A thin-walled cantilever of QRO-profile is fully fixed on the left end, and the warping is enabled. The cantilever is subjected to a torque.

Bending Cantilever with Axial Force

A cantilever is loaded by a transversal and an axial force on the right end and it is fully fixed on the left end. The problem is described by the following set of parameters. The problem is solved by means of the geometrically linear analysis, second order analysis and large deformation analysis.

Uniaxial Bending with Pressure

A structure made of I-profile is fully fixed on the left end and embedded into the sliding support on the right end. The structure consists of two segments.

Pinned Beam Subjected to Bending

Beam pinned at the both ends is loaded with the concentrated force at the middle. Neglecting its self-weight and shear stiffness, determine beam's maximum deflection, normal force and moment at the mid-span assuming the second and the third order theory.

Twisted Beam Under Complex Loads with Warping

A beam is fully fixed (warping is restraint) on the left end and supported by the fork support (warping is enabled) on the right end. The beam is subjected to a torque, longitudinal force and transverse force.

Cantilever Under the Torsion with Warping

A cantilever of I-profile is supported on the left end and it is loaded by the torque. The aim of this example is to compare the fixed support with the fork support and to investigate the behaviour of some representative quantities. The comparison with the solution by means of plates is also made.

Stability of a Beam Subjected to the Combined Loading

A steel beam with a square cross-section is loaded with an axial force and a distributed loading. Calculation of the maximum bending deflection and the critical load factor according second order analysis.

Procurar exemplo

Programa / módulo

Modelo de material

Método de cálculo

Entidade do modelo

Função especial


Receba regularmente informação sobre novidades, dicas úteis, eventos planeados, ofertas especiais e vales.

Base de dados de conhecimento

Base de dados de conhecimento

Na página ‘Base de dados de conhecimento’ pode encontrar vários artigos técnicos assim como sugestões e truques que se podem tornar úteis na resolução de problemas de engenharia estrutural com os programas da Dlubal Software.