A thin circular ring of a rectangular cross-section is exposed to external pressure. Determine the critical load and corresponding load factor for in-plane buckling.
Do you have any questions?
Knowledge Base
Length: 00:00:51 min
Length: 00:00:26 min
Length: 02:30:54 min
Length: 01:09:33 min
Knowledge Base
Length: 00:00:49 min
Customer Project
Length: 00:00:05 min
Customer Project
Length: 00:00:05 min
Knowledge Base
Length: 00:00:18 min
Length: 00:00:44 min
Dlubal_KohlA_]_LI.jpg?mw=350&hash=ee8d38f1c4853d80307fa156c159b5e78a3fdca9)
The function, which is also known as shifting, allows you to calculate critical load factors beyond a user‑defined initial value. Determination of the critical load factors is usually done from the smallest to the greatest critical load factor.
A calculation break‑off due to an unstable system can have different reasons. On one hand, it can indicate a "real" instability due to overloading of the system; on the other hand, the error message can result from inaccuracies in the model.
If a member is supported laterally to prevent buckling due to a compressive axial force, it must be ensured that the lateral support is actually able to prevent buckling. Therefore, the aim of this article is to determine the ideal spring stiffness of a lateral support using the Winter model.
The previous article, titled Lateral-Torsional Buckling in Timber Construction | Examples 1, explains the practical application for determining the critical bending moment Mcrit or the critical bending stress σcrit for a bending beam's lateral buckling using simple examples. In this article, the critical bending moment is determined by considering an elastic foundation resulting from a stiffening bracing.
In RFEM and RSTAB, you can visualize the flow field quantities of pressure, velocity, turbulence kinetic energy, and turbulence dissipation rate for the wind simulation.
The clipping planes are aligned with the respective wind direction.
In the ultimate configuration of the steel joint design, you have the option to modify the limit plastic strain for welds.
Using the "Base Plate" component, you can design base plate connections with cast-in anchors. In addition to plates and welds, the design analyzes the anchorage and the steel-concrete interaction.
In RFEM, you can generate surfaces from members with the library cross-sections as well as from the members with the RSECTION cross-section.
How are the effective lengths of frame columns determined in RFEM or RSTAB?
How can I export the effective lengths from the RF‑STABILITY add-on module to Excel?
What is the critical load factor and how is it possible to determine it?
I have calculated a pre-deformed structure according to the second-order analysis with RF‑STABILITY and RF‑IMP. Why are the deformations of the CO smaller than the applied pre-deformation?
Is it possible to perform stability analyses on reinforced concrete structures by means of RF‑STABILITY?
My model is unstable. What can be the cause?
.JPG?mw=350&hash=b46b677f0a58c9c1ef905d33f3a09a84cbaad85b)
