Железобетонная плита внутри здания должна быть спроектирована в виде полосы 1,0 м со стержнями. Плита перекрытия одноосно перекрыта и проходит через два пролета. Плита крепится к кирпичной стене с помощью свободно вращающихся опор. Средняя опора имеет ширину 240 мм, а две краевые опоры - 120 мм. На два пролета действует нагрузка категории C: районы собраний.
Симметричная конструкция мелкого заложения состоит из восьми одинаковых ферм, встроенных в шарнирные опоры. The structure is loaded by a concentrated force and alternatively by imposed nodal deformation over the critical limit point when the snap-through occurs. Imposed nodal deformation is used in RFEM 5 and RSTAB 8 to obtain the full equilibrium path of the snap-through. The self-weight is neglected in this example. Determine the relationship between the actual loading force and the deflection, considering large deformation analysis. Evaluate the load factor at the given deflections.
Конструкция состоит из четырех ферм, встроенных в шарнирные опоры. The structure is loaded by a concentrated force and alternatively by imposed nodal deformation over the critical limit point, when snap-through occurs. Imposed nodal deformation is used in RFEM 5 and RSTAB 8 to obtain the full equilibrium path of the snap-through. The self-weight is neglected in this example. Determine the relationship between the actual loading force and the deflection, considering large deformation analysis. Evaluate the load factor at given deflections.
A cantilever beam with an I-beam cross-section of length L is defined. The beam has five mass points with masses m acting in the X-direction. Собственный вес не учитывается. The frequencies, mode shapes, and equivalent loads of this 5-DOF system are analytically calculated and compared with the results from RSTAB and RFEM.
Мы определим постоянную кручения для сечения трубки (кольцевая площадь) аналитически и сравним полученные результаты с численным решением в RFEM 5 и RSTAB 8 для различной толщины стенки.