В дополнительном модуле RF-CONCRETE Surfaces возможно выполнять также расчет железобетонных поверхностей для плит перекрытий и стен по норме ACI 318-19 или CSA A23.3-19. Общим методом в расчете пластин обычно является применение расчетных полос для определения значений средних одноосных внутренних сил по ширине полосы. Но в случае плит применит метод расчетных полос к двухосному элементу плиты более простой одноосный подход и на его основе затем определит требуемый объем арматуры по длине полосы.
In the AISC 360 – 14th Ed. C2.2, the direct analysis method requires initial imperfections to be taken into consideration. The important imperfection of recognition is column out-of-plumbness. According to C2.2a, the direct modeling of imperfections is one method to account for the effect of initial imperfections. However, in many situations, the expected displacements may not be known or easily predicted.
Requirements for the design of structural stability are given in the AISC 360 – 14th Ed. Chapter C. In particular, the direct analysis method provisions, previously located in Appendix 7 of the AISC 360 – 13th Ed., are described in detail. This method is considered an alternative to the effective length method, which in turn eliminates the need for effective length (K) factors other than 1.0.