В вилочные опоры затем встроена конструкция из двутаврового профиля. The axial rotation is restricted on both ends while warping is enabled. The structure is loaded by two transverse forces in the middle. The verification example is based on the example introduced by Gensichen and Lumpe.
Плоская ферма, состоящая из четырех наклонных стержней и одного вертикального стержня, загружена в верхнем узле вертикальной и внеплоской силой. Assuming the large deformation analysis and neglecting the self-weight, determine the normal forces of the members and the out-of-plane displacement of the upper node.
Стержень W-образного сечения ASTM A992 выбирается таким образом, чтобы выдерживать собственный вес 30 000 тысяч фунтов и временную нагрузку 90 000 тысяч фунтов при растяжении. Verify the member strength using both LRFD and ASD.
Плотная винтовая пружина нагружена сжимающей силой. The spring has middle diameter D, wire diameter d, and it consists of i turns. The total length of the spring is L. Determine the total deflection of the spring for the member model and one‑turn deflection for the solid model.
Стержень с небольшим наклоном, нагруженный сосредоточенной силой, удерживается на одном конце пружиной, а на другом конце. Assuming large deformations and neglecting the member's self-weight, determine its maximum upward deflection.
Конструкция из двутаврового профиля полностью закреплена на левом конце и встроена в подвижную опору на правом конце. The structure consists of two segments. The self-weight is neglected in this example. Determine the maximum deflection of the structure, the bending moment on the fixed end, the rotation of segment 2, and the reaction force at point B by means of the geometrically linear analysis and the second-order analysis. The verification example is based on the example introduced by Gensichen and Lumpe.
Тонкостенная консоль из QRO-профиля полностью закреплена на левом конце, и депланация включена. The cantilever is subjected to torque. Small deformations are considered, and the self-weight is neglected. Determine the maximum rotation, primary moment, secondary moment, and warping moment. The verification example is based on the example introduced by Gensichen and Lumpe.
На левом конце поддерживается двутавровая консоль, которая нагружена крутящим моментом. The aim of this example is to compare the fixed support with the fork support and to investigate the behavior of some representative quantities. Comparison is also made to the solution by means of plates. Small deformations are considered, and the self-weight is neglected. Determine the rotation in the midpoint of the cantilever, and in case of the member entity with warping, determine the values of the primary torsional moment, the secondary torsional moment, and the warping moment both on the left end (point A) and the right end (point B).