在两个同心圆柱体的两个半径半径之间的各向同性预应力拉伸膜,该预应力位于一个不与竖轴平行的平面上。 Find the final minimum shape of the membrane - the helicoid - and determine the surface area of the resulting membrane. The add-on module RF-FORM-FINDING is used for this purpose. Elastic deformations are neglected both in RF-FORM-FINDING and in the analytical solution; self-weight is also neglected in this example.
截面为 ASTM A992 W 18×50 的梁用于跨度和均布活荷载,如图 1 所示。 The member is limited to a maximum nominal depth of 18 inches. The live load deflection is limited to L/360. The beam is simply supported and continuously braced. Verify the available flexural strength of the selected beam, based on LRFD and ASD.
定义一个简单振动器,由质量 m(只考虑 x 方向)和刚度为 k 的弹簧组成。 The mass is embedded on a surface with Coulomb friction and is loaded by constant-in-time axial and transverse forces.
假设在脚手架底部设置了一个刚性圆筒,该圆筒由一个弯矩和一个力来定义。 Calculate the maximum radial deflection by exceeding the capacity of the scaffolding support.
施加集中质量的细长梁,并施加一个随时间变化的力。 It is simply supported. The problem is described using the following parameters. Determine the deflections in the given test times.
左端支承一个 I 形截面的悬臂梁,图中显示了扭矩荷载。 The aim of this example is to compare the fixed support with the fork support and to investigate the behavior of some representative quantities. Comparison is also made to the solution by means of plates. Small deformations are considered, and the self-weight is neglected. Determine the rotation in the midpoint of the cantilever, and in case of the member entity with warping, determine the values of the primary torsional moment, the secondary torsional moment, and the warping moment both on the left end (point A) and the right end (point B).
在两端固定一个三维的弹塑性材料块。 The block's middle plane is subjected to a pressure load. The surface plasticity is described according to the Tsai-Wu plasticity theory.
计算两端固定的三维试块的最大挠度。 The block is divided in the middle: the upper half is made of an elastic material and the lower part is made of timber - an elasto-plastic othotropic material with the yield surface described according to the Tsai-Wu plasticity theory. The block's middle plane is subjected to vertical pressure.