На рисунке 1 показана балка ASTM A992 W 24x62 со сдвигом на концах 48 000 и 145 000 kips от постоянной и временной нагрузки соответственно. Verify the available shear strength of the selected beam, based on LRFD and ASD.
Балка полностью закреплена (депланация ограничена) на левом конце и поддерживается вилочной опорой (депланация включена) на правом конце. The beam is subjected to a torque, longitudinal force, and transverse force. Determine the behavior of the primary torsional moment, secondary torsional moment, and warping moment. The verification example is based on the example introduced by Gensichen and Lumpe.
Стержень с заданными граничными условиями нагружен крутящим моментом и нормальной силой. Neglecting its self-weight, determine the beam's maximum torsional deformation as well as its inner torsional moment, defined as the sum of a primary torsional moment and torsional moment caused by the normal force. Provide a comparison of those values while assuming or neglecting the influence of the normal force. The verification example is based on the example introduced by Gensichen and Lumpe.
Тонкостенная консоль из QRO-профиля полностью закреплена на левом конце, и депланация включена. The cantilever is subjected to torque. Small deformations are considered, and the self-weight is neglected. Determine the maximum rotation, primary moment, secondary moment, and warping moment. The verification example is based on the example introduced by Gensichen and Lumpe.
К тому же, на свободном конце консоли действует момент, Using the geometrically linear analysis and large deformation analysis, and neglecting the beam's self-weight, determine the maximum deflections at the free end. The verification example is based on the example introduced by Gensichen and Lumpe.
Колонна состоит из бетонного сечения (прямоугольник 100/200) и стального сечения (профиль I 200). It is subjected to pressure force. Determine the critical load and corresponding load factor. The theoretical solution is based on the buckling of a simple beam. In this case, two regions have to be taken into account due to different moments of inertia and material properties.
Конструкция из двутаврового профиля полностью закреплена на левом конце и встроена в подвижную опору на правом конце. The structure consists of two segments. The self-weight is neglected in this example. Determine the maximum deflection of the structure, the bending moment on the fixed end, the rotation of segment 2, and the reaction force at point B by means of the geometrically linear analysis and the second-order analysis. The verification example is based on the example introduced by Gensichen and Lumpe.
В вилочные опоры затем встроена конструкция из двутаврового профиля. The axial rotation is restricted on both ends while warping is enabled. The structure is loaded by two transverse forces in the middle. The verification example is based on the example introduced by Gensichen and Lumpe.
Consider an ASTM A992 W 18×50 beam forspan and uniform dead and live loads as shown in Figure 1. Стержень ограничен максимальной номинальной высотой 18 дюймов (45,72 см). The live load deflection is limited to L/360. The beam is simply supported and continuously braced. Verify the available flexural strength of the selected beam, based on LRFD and ASD.