该结构由一个工字钢和两个桁架组成。 The structure contains several imperfections and it is loaded by the force Fz. 示例中忽略自重。 Determine the deflections uy and uz and axial rotation φx at the endpoint (Point 4). 验算示例是基于 Gensichen 和 Lumpe 介绍的示例.
该验算示例是基于验算示例 0122 编写的. A single-mass system without damping is subjected to an axial loading force. An ideal elastic-plastic material with characteristics is assumed. Determine the time course of the end-point deflection, velocity, and acceleration.
一个对称的浅结构结构,由八个相同的桁架构件组成,这些桁架嵌在铰支座中。 The structure is loaded by a concentrated force and alternatively by imposed nodal deformation over the critical limit point when the snap-through occurs. Imposed nodal deformation is used in RFEM 5 and RSTAB 8 to obtain the full equilibrium path of the snap-through. The self-weight is neglected in this example. Determine the relationship between the actual loading force and the deflection, considering large deformation analysis. Evaluate the load factor at the given deflections.
该结构由四个桁架杆件组成,桁架铰接。 The structure is loaded by a concentrated force and alternatively by imposed nodal deformation over the critical limit point, when snap-through occurs. Imposed nodal deformation is used in RFEM 5 and RSTAB 8 to obtain the full equilibrium path of the snap-through. The self-weight is neglected in this example. Determine the relationship between the actual loading force and the deflection, considering large deformation analysis. Evaluate the load factor at given deflections.
设置阻尼器的单质量系统受到恒定的荷载。 Determine the deflection and velocity of the dashpot endpoint in the given test time.
一根细柱由初始应变张拉并初始变形。 Determine the deflection of the test point at the given test times.
本示例介绍由摩擦引起的不可逆过程。 After the loading and unloading, the end-point is in a different position than where it was at the beginning. Determine the movement of the node in the X direction.
左端是一个完全固定的工字形截面结构,右端是嵌在可滑动支座中的结构。 The structure consists of two segments. The self-weight is neglected in this example. Determine the maximum deflection of the structure, the bending moment on the fixed end, the rotation of segment 2, and the reaction force at point B by means of the geometrically linear analysis and the second-order analysis. The verification example is based on the example introduced by Gensichen and Lumpe.
左端支承一个 I 形截面的悬臂梁,图中显示了扭矩荷载。 The aim of this example is to compare the fixed support with the fork support and to investigate the behavior of some representative quantities. Comparison is also made to the solution by means of plates. Small deformations are considered, and the self-weight is neglected. Determine the rotation in the midpoint of the cantilever, and in case of the member entity with warping, determine the values of the primary torsional moment, the secondary torsional moment, and the warping moment both on the left end (point A) and the right end (point B).
定义悬臂梁为工字形,截面长度为 L。 The beam has five mass points with masses m acting in the X-direction. The self-weight is neglected. The frequencies, mode shapes, and equivalent loads of this 5-DOF system are analytically calculated and compared with the results from RSTAB and RFEM.