Una barra con las condiciones de contorno dadas está cargada por el momento torsor y el esfuerzo axil. Omitiendo su peso propio, determine la deformación torsional máxima de la viga, así como su momento torsor interno, definido como la suma de un momento torsor primario y un momento torsor causado por el esfuerzo axil. Proporcione una comparación de esos valores asumiendo o ignorando la influencia del esfuerzo axil. El ejemplo de verificación se basa en el ejemplo presentado por Gensichen y Lumpe.
Una estructura hecha de un perfil en I está incrustada en los apoyos de la horquilla. The axial rotation is restricted on both ends while warping is enabled. The structure is loaded by two transverse forces in the middle. The verification example is based on the example introduced by Gensichen and Lumpe.
Una viga de un cuarto de círculo con una sección rectangular está cargada por medio de una fuerza fuera del plano. This force causes a bending moment, torsional moment, and transverse force. While neglecting self-weight, determine the total deflection of the curved beam.
Un sistema de doble masa consta de dos ejes y dos masas representadas por los momentos de inercia correspondientes, concentrados en una distancia dada como masas en nudos. The left shaft is fixed, and the right mass is free. Neglecting the self‑weight of the shafts, determine the torsional natural frequencies of the system.
Un voladizo de pared delgada de un perfil QRO está completamente fijado en el extremo izquierdo y el alabeo está habilitado. The cantilever is subjected to torque. Small deformations are considered, and the self-weight is neglected. Determine the maximum rotation, primary moment, secondary moment, and warping moment. The verification example is based on the example introduced by Gensichen and Lumpe.
Una barra con las condiciones de contorno dadas está cargada por el momento torsor y el esfuerzo axil. Neglecting its self-weight, determine the beam's maximum torsional deformation as well as its inner torsional moment, defined as the sum of a primary torsional moment and torsional moment caused by the normal force. Provide a comparison of those values while assuming or neglecting the influence of the normal force. The verification example is based on the example introduced by Gensichen and Lumpe.
Una viga está completamente fija (el alabeo está restringido) en el extremo izquierdo y está apoyada en un apoyo en horquilla (el alabeo está habilitado) en el extremo derecho. The beam is subjected to a torque, longitudinal force, and transverse force. Determine the behavior of the primary torsional moment, secondary torsional moment, and warping moment. The verification example is based on the example introduced by Gensichen and Lumpe.
Un voladizo de perfil en I está apoyado en el extremo izquierdo y cargado por el par. The aim of this example is to compare the fixed support with the fork support and to investigate the behavior of some representative quantities. Comparison is also made to the solution by means of plates. Small deformations are considered, and the self-weight is neglected. Determine the rotation in the midpoint of the cantilever, and in case of the member entity with warping, determine the values of the primary torsional moment, the secondary torsional moment, and the warping moment both on the left end (point A) and the right end (point B).
Determine analíticamente la constante de torsión para la sección del tubo (área anular) y compare los resultados con la solución numérica en RFEM 5 y RSTAB 8 para varios espesores de pared.