回复:
在 RFEM 6 的当前状态下，用户必须手动定义杆件的剪力和纵向钢筋。 This is considered the "Provided Reinforcement" within the Concrete Design add-on. The add-on calculation will then determine the "Required Reinforcement" needed from the analysis and further output the "Not Covered Reinforcement". The user must manually apply additional reinforcement if the "Required Reinforcement" is not met.
For surfaces RFEM 6 can design automatically the reinforcement.
It is planned for the future to have an automatic design also of the member reinforcement rather than only the manual input option.
常见问题和解答 (FAQ)
