Una losa de hormigón armado dentro de un edificio se debe diseñar como una línea de 1,0 m con barras. La losa es unidireccional y discurre por dos vanos. La losa está fijada a muros de mampostería con apoyos libres de giro. El apoyo del medio tiene un ancho de 240 mm y los dos apoyos de los bordes tienen un ancho de 120 mm. Los dos vanos están sometidos a una sobrecarga de uso de categoría C: zonas de reunión.
Una estructura superficial simétrica se compone de ocho barras de celosía iguales, que están incrustadas en los apoyos de las articulaciones. The structure is loaded by a concentrated force and alternatively by imposed nodal deformation over the critical limit point when the snap-through occurs. Imposed nodal deformation is used in RFEM 5 and RSTAB 8 to obtain the full equilibrium path of the snap-through. The self-weight is neglected in this example. Determine the relationship between the actual loading force and the deflection, considering large deformation analysis. Evaluate the load factor at the given deflections.
Una estructura se compone de cuatro barras de celosía, que están incrustadas en apoyos de articulación. The structure is loaded by a concentrated force and alternatively by imposed nodal deformation over the critical limit point, when snap-through occurs. Imposed nodal deformation is used in RFEM 5 and RSTAB 8 to obtain the full equilibrium path of the snap-through. The self-weight is neglected in this example. Determine the relationship between the actual loading force and the deflection, considering large deformation analysis. Evaluate the load factor at given deflections.
A cantilever beam with an I-beam cross-section of length L is defined. The beam has five mass points with masses m acting in the X-direction. Se omite el peso propio. The frequencies, mode shapes, and equivalent loads of this 5-DOF system are analytically calculated and compared with the results from RSTAB and RFEM.
Determine analíticamente la constante de torsión para la sección del tubo (área anular) y compare los resultados con la solución numérica en RFEM 5 y RSTAB 8 para varios espesores de pared.