A thin rectangular orthotropic plate is simply supported and loaded by uniformly distributed pressure. The directions of axes x and y coincide with the principal directions. Determine la deformación máxima de la placa sin considerar el peso propio.
Una placa elíptica con un contorno de sujeción está sujeta a una carga transversal distribuida uniformemente. Assuming the small deformation theory and neglecting the self‑weight, the maximum out‑of‑plane deflection of the plate is determined.
Una placa triangular equilátera simplemente apoyada está sometida a una carga transversal distribuida uniformemente. Assuming the small deformation theory and neglecting self‑weight, the maximum out‑of‑plane deflection of the plate is determined.
Este ejemplo sirve como demostración de la coacción del diafragma. The application is shown on a two-story structure. The structure is loaded by means of lateral forces according to Figure 1. Determine the maximum deflection of the structure ux in the direction of the loading forces using both the diaphragm constraint and the plate model of the floor.
Una placa compuesta que consta de tres capas de vidrio, una capa de lámina y un espacio interior con aire seco, está completamente fijada y cargada con una temperatura variable. Neglecting its self-weight, determine the plate's maximum deflection.
Determine la flecha máxima del voladizo que consta de dos capas de vidrio y una capa de lámina intermedia. The plate is fully fixed at one end and subjected to uniform pressure.
Un voladizo de perfil en I está apoyado en el extremo izquierdo y cargado por el par. The aim of this example is to compare the fixed support with the fork support and to investigate the behavior of some representative quantities. Comparison is also made to the solution by means of plates. Small deformations are considered, and the self-weight is neglected. Determine the rotation in the midpoint of the cantilever, and in case of the member entity with warping, determine the values of the primary torsional moment, the secondary torsional moment, and the warping moment both on the left end (point A) and the right end (point B).
Una placa ortótropa cuadrada en capas está completamente fijada en su punto medio y sometida a presión. Compare the deflections of the plate corners to check the correctness of the transformation.
Una placa ancha con un agujero está cargada en una dirección por la tensión de tracción. The plate width is large with respect to the hole radius, and it is very thin, considering the state of the plane stress.