FAQ 001054 ZH

建模 | 结构 RFEM RSTAB

For a steel frame, I have manually created 20 load combinations with partial safety factors. The deformations, however, are to be determined without factors. I proceed as follows:

  • I copy every single LC (several load combinations cannot be copied simultaneously)
  • I set the factor to 1.0 in every LC.

Is there no easier way to do this?

回答

For manually created load combinations with single loadings, there is, unfortunately, only the option that you described.

Alternatively, however, you can create the combinations automatically by using the General Data dialog box. As combination expressions, you can use not only the ultimate limit state, but also various design situations for the serviceability limit state: 'Characteristic', 'Frequent,' or 'Quasi-permanent'. In this way, the partial safety factors are automatically applied correctly.

联系我们

联系 Dlubal

您找到想找的问题和解答了吗?
如果没有,请联系我们或者把您的问题通过网上表格递交给我们。

+49 9673 9203 0

(可要求接中文热线)

info@dlubal.com

RFEM 主程序 RFEM
RFEM 5.xx

主程序

结构设计与有限元­分析软件(FEA)可以用于建立平面与空间结构模型,适用于由杆件、面、板、墙、折板、膜、壳、实体以及接触单元等的建模与分析计算。

RSTAB 主程序
RSTAB 8.xx

主程序

空间结构设计与分析软件,主要用于框架、梁与桁架等空间结构的建模与计算。可以输出内力、变形与制作反力的线性与非线性的计算结果。