Dans l'exemple de validation actuel, nous étudions le coefficient de pression du vent (Cp) d'une toiture plate et de murs avec l'ASCE7-22 [1]. La section 28.3 (Charges de vent - système principal résistant au vent) et la Figure 28.3-1 (cas de charge 1) présentent un tableau indiquant la valeur de Cp pour différents angles de toiture.
Une plaque orthotrope rectangulaire mince est simplement supportée et chargée par une pression uniformément répartie. The directions of axes x and y coincide with the principal directions. While neglecting self-weight, determine the maximum deflection of the plate.
Une plaque elliptique avec un contour articulé est soumise à une charge transversale uniformément distribuée. Assuming the small deformation theory and neglecting the self‑weight, the maximum out‑of‑plane deflection of the plate is determined.
Une plaque triangulaire équilatérale simplement supportée est soumise à une charge transversale uniformément répartie. Assuming the small deformation theory and neglecting self‑weight, the maximum out‑of‑plane deflection of the plate is determined.
Cet exemple sert de démonstration du couplage de diaphragme. The application is shown on a two-story structure. The structure is loaded by means of lateral forces according to Figure 1. Determine the maximum deflection of the structure ux in the direction of the loading forces using both the diaphragm constraint and the plate model of the floor.
Une plaque mixte composée de trois couches de verre, d'une couche de aluminium et d'un espace intérieur contenant de l'air sec est entièrement fixée et chargée à température variable. Neglecting its self-weight, determine the plate's maximum deflection.
Déterminez la flèche maximale du porte-à-faux composé de deux couches de verre et d'une couche de feuille entre les deux. The plate is fully fixed at one end and subjected to uniform pressure.
Un porte-à-faux profilé en I est supporté à l'extrémité gauche et chargé par un couple. The aim of this example is to compare the fixed support with the fork support and to investigate the behavior of some representative quantities. Comparison is also made to the solution by means of plates. Small deformations are considered, and the self-weight is neglected. Determine the rotation in the midpoint of the cantilever, and in case of the member entity with warping, determine the values of the primary torsional moment, the secondary torsional moment, and the warping moment both on the left end (point A) and the right end (point B).
Une plaque orthotrope carrée en couches est complètement encastrée en son point central et soumise à la pression. Compare the deflections of the plate corners to check the correctness of the transformation.
Une plaque large avec un trou est chargée dans une direction par une contrainte de traction. The plate width is large with respect to the hole radius, and it is very thin, considering the state of the plane stress.