Une membrane de diaphragme sphérique est remplie de gaz avec une pression atmosphérique et un volume défini (ces valeurs sont utilisées uniquement pour la définition du modèle EF). Determine the overpressure inside the balloon due to the given isotropic membrane prestress. The add-on module RF-FORM-FINDING is used for this purpose. Elastic deformations are neglected both in RF-FORM-FINDING and in the analytical solution; self-weight is also neglected in this example.
Une poutre courbe est composée de deux poutres de section rectangulaire. The horizontal beam is loaded by distributed loading. While neglecting self-weight, determine the maximum stress on the top surface of the horizontal beam.
Un réservoir sphérique à parois minces est chargé par une pression interne. While neglecting self‑weight, determine the von Mises stress and the radial deflection of the vessel.
Un oscillateur simple est composé de la masse m (considérée uniquement dans la direction x) et du ressort linéaire de rigidité k. The mass is embedded on a surface with Coulomb friction and is loaded by constant-in-time axial and transverse forces.
Un porte-à-faux à section circulaire est chargé par une force de flexion et un moment de flexion concentrés. The aim of this verification example is to compare the reduced stress according to the von Mises and Tresca theories.
A two-layered, open-ended, thick-walled vessel is loaded by inner and outer pressure; therefore, there is no axial stress. En négligeant le poids propre, la flèche radiale des rayons internes et externes, et la pression (contrainte radiale) du rayon central est déterminée.
Un disque compact (CD) tourne à une vitesse de 10 000 t/min. Therefore, it is subjected to centrifugal force. The problem is modeled as a quarter model. Determine the tangential stress on the inner and outer diameters and the radial deflection of the outer radius.
Le but de cet exemple est de démontrer un processus irréversible causé par une friction. After the loading and unloading, the end-point is in a different position than where it was at the beginning. Determine the movement of the node in the X direction.
Quatre poteaux sont encastrés en bas et reliés par un bloc rigide en haut. The block is loaded by pressure and modeled by an elastic material with a high modulus of elasticity. The outer columns are modeled by linear elastic material and the inner columns by a stress-strain diagram with decaying dependence. Assuming only the small deformation theory and neglecting the structure's self-weight, determine its maximum deflection.
Déterminer la flèche maximale d'un cube. The cube's lower side is fully fixed and the upper side is subjected to shear loading.
Une plaque large avec un trou est chargée dans une direction par une contrainte de traction. The plate width is large with respect to the hole radius, and it is very thin, considering the state of the plane stress.