Cet article décrit comment la dalle plate d'un bâtiment résidentiel est modélisée dans RFEM 6 puis calculée selon l'Eurocode 2. La dalle fait 24 cm d'épaisseur et est supportée par des poteaux de 45/45/300 cm de long espacés de 6,75 m en direction X et Y (Figure 1). Les poteaux sont modélisés sous forme d'appuis nodaux élastiques en déterminant la rigidité du ressort à partir des conditions aux limites (Figure 2). Le béton C35/45 et l'acier de béton armé B 500 S (A) ont été sélectionnés comme matériaux.
In the AISC 360 – 14th Ed. C2.2, the direct analysis method requires initial imperfections to be taken into consideration. The important imperfection of recognition is column out-of-plumbness. According to C2.2a, the direct modeling of imperfections is one method to account for the effect of initial imperfections. However, in many situations, the expected displacements may not be known or easily predicted.
Requirements for the design of structural stability are given in the AISC 360 – 14th Ed. Chapter C. In particular, the direct analysis method provisions, previously located in Appendix 7 of the AISC 360 – 13th Ed., are described in detail. This method is considered an alternative to the effective length method, which in turn eliminates the need for effective length (K) factors other than 1.0.