Une dalle en béton armé à l'intérieur d'un bâtiment doit être calculée comme une bande de 1,0 m avec des barres. Le radier est à travée uniaxiale et traverse deux travées. La dalle est fixée sur des murs en maçonnerie avec des appuis libres. L'appui central a une largeur de 240 mm et les deux appuis latéraux ont une largeur de 120 mm. Les deux travées sont soumises à une charge imposée de catégorie C : zones de rassemblement.
A symmetrical shallow structure is made of eight equal truss members, which are embedded into hinge supports. The structure is loaded by a concentrated force and alternatively by imposed nodal deformation over the critical limit point when the snap-through occurs. Imposed nodal deformation is used in RFEM 5 and RSTAB 8 to obtain the full equilibrium path of the snap-through. Le poids propre est négligé dans cet exemple. Determine the relationship between the actual loading force and the deflection, considering large deformation analysis. Evaluate the load factor at the given deflections.
A structure is made of four truss members, which are embedded into hinge supports. The structure is loaded by a concentrated force and alternatively by imposed nodal deformation over the critical limit point, when snap-through occurs. Imposed nodal deformation is used in RFEM 5 and RSTAB 8 to obtain the full equilibrium path of the snap-through. Le poids propre est négligé dans cet exemple. Determine the relationship between the actual loading force and the deflection, considering large deformation analysis. Evaluate the load factor at given deflections.
A cantilever beam with an I-beam cross-section of length L is defined. The beam has five mass points with masses m acting in the X-direction. le poids propre est négligé. The frequencies, mode shapes, and equivalent loads of this 5-DOF system are analytically calculated and compared with the results from RSTAB and RFEM.
Déterminez analytiquement le moment d'inertie de torsion de la section du tuyau et comparez les résultats avec la solution numérique dans RFEM 5 et RSTAB 8 pour différentes épaisseurs de paroi.