L'esempio di verifica descrive i carichi del vento in diverse direzioni del vento su un modello di un gruppo di edifici. The model consists of eight cubes. The velocity fields obtained by the RWIND simulation are compared with the measured values from the experiment. The experimental data are measured using a thermistor anemometer in the wind tunnel.
L'esempio di verifica descrive i carichi di pressione sulle pareti di edifici in disposizione in tandem situati a livello del suolo. The buildings are simplified to rectangular objects and scaled down while maintaining the elevation ratios. The pressure distribution on the walls of the model of a medium-high building was conducted by an experiment. The chosen results (pressure coefficient Cp) are compared with the measured values.
L'esempio di verifica descrive il flusso in stato stazionario attorno a un grattacielo in blocchi urbani (modello in scala). The example is given by the Architectural Institute of Japan (AIJ). The chosen results (velocity magnitude) are compared with the measured values.
L'esempio di verifica descrive il flusso in stato stazionario attorno a un edificio isolato (modello in scala).L'esempio è fornito dall'Architectural Institute of Japan (AIJ). The chosen results (velocity magnitude) are compared with the measured values.
Un'asta con le condizioni al contorno date è caricata dal momento torcente e dalla forza assiale. Neglecting its self-weight, determine the beam's maximum torsional deformation as well as its inner torsional moment, defined as the sum of a primary torsional moment and torsional moment caused by the normal force. Provide a comparison of those values while assuming or neglecting the influence of the normal force. The verification example is based on the example introduced by Gensichen and Lumpe.
Uno sbalzo con profilo a I è supportato sull'estremità sinistra e caricato dalla coppia. The aim of this example is to compare the fixed support with the fork support and to investigate the behavior of some representative quantities. Comparison is also made to the solution by means of plates. Small deformations are considered, and the self-weight is neglected. Determine the rotation in the midpoint of the cantilever, and in case of the member entity with warping, determine the values of the primary torsional moment, the secondary torsional moment, and the warping moment both on the left end (point A) and the right end (point B).