Una sottile piastra ortotropa rettangolare è semplicemente supportata e caricata da una pressione uniformemente distribuita. The directions of axes x and y coincide with the principal directions. While neglecting self-weight, determine the maximum deflection of the plate.
Una piastra di acciaio rettangolare di dimensioni è semplicemente supportata ai suoi bordi. Determine the natural frequencies of the rectangular plate.
Una piastra ellittica con un contorno bloccato è soggetta a un carico trasversale uniformemente distribuito. Assuming the small deformation theory and neglecting the self‑weight, the maximum out‑of‑plane deflection of the plate is determined.
Una piastra triangolare equilatera semplicemente supportata è soggetta ad un carico trasversale uniformemente distribuito. Assuming the small deformation theory and neglecting self‑weight, the maximum out‑of‑plane deflection of the plate is determined.
Questo esempio serve come dimostrazione del vincolo del diaframma. The application is shown on a two-story structure. The structure is loaded by means of lateral forces according to Figure 1. Determine the maximum deflection of the structure ux in the direction of the loading forces using both the diaphragm constraint and the plate model of the floor.
Una piastra composita composta da tre strati di vetro, uno strato di lamina e uno spazio interno con aria secca, è completamente fissata e caricata con una temperatura variabile. Neglecting its self-weight, determine the plate's maximum deflection.
Determina l'inflessione massima dello sbalzo costituito da due strati di vetro e uno strato di lamina nel mezzo. The plate is fully fixed at one end and subjected to uniform pressure.
Uno sbalzo con profilo a I è supportato sull'estremità sinistra e caricato dalla coppia. The aim of this example is to compare the fixed support with the fork support and to investigate the behavior of some representative quantities. Comparison is also made to the solution by means of plates. Small deformations are considered, and the self-weight is neglected. Determine the rotation in the midpoint of the cantilever, and in case of the member entity with warping, determine the values of the primary torsional moment, the secondary torsional moment, and the warping moment both on the left end (point A) and the right end (point B).
Una piastra ortotropa quadrata stratificata è completamente fissata nel suo punto centrale e sottoposta a pressione. Compare the deflections of the plate corners to check the correctness of the transformation.
Una piastra larga con un foro è caricata in una direzione dalla tensione di trazione. The plate width is large with respect to the hole radius, and it is very thin, considering the state of the plane stress.