Reinforced concrete surface design for slabs, plates, and walls is possible in the RF-CONCRETE Surfaces module according to the ACI 318-19 or the CSA A23.3-19 standard. A common approach for slab design is the use of design strips for determining the average one-way internal forces over the width of the strip. This design strip method essentially takes a two-way slab element and applies a simpler one-way approach to determine the required reinforcement needed along the strip length.
In der Standardeinstellung wird in den Bemessungsmodulen die Querschnittsklasse für jeden Stab und Lastfall automatisch bestimmt. In der Eingabemaske der Querschnitte kann der Nutzer die Querschnittsklasse jedoch auch manuell vorgeben, zum Beispiel wenn lokales Beulen konstruktiv ausgeschlossen ist.
In den Zusatzmodulen RF-/HOLZ Pro, RF-/HOLZ AWC und RF-/HOLZ CSA ist es möglich, die resultierende Verformung eines Stabes oder Stabsatzes zu berücksichtigen. Neben den lokalen Richtungen y und z steht die Option "R" zur Verfügung. Damit kann die Gesamtdurchbiegung eines Trägers den in den Normen angegebenen Grenzwerten gegenübergestellt werden.
Using the RF-TIMBER CSA module, timber beam design is possible according to the CSA O86-14 standard. Accurately calculating timber member bending resistance and adjustment factors is important for safety considerations and design. The following article will verify the factored bending moment resistance in the RFEM add-on module RF-TIMBER CSA using step-by-step analytical equations as per the CSA O86-14 standard including the bending modification factors, factored bending moment resistance, and final design ratio.
Using the RF-TIMBER CSA module, timber column design is possible according to the CSA O86-19 standard. Accurately calculating timber member compressive resistance and adjustment factors is important for safety considerations and design. The following article will verify the factored compressive resistance in the RFEM add-on module RF-TIMBER CSA, using step-by-step analytical equations as per the CSA O86-19 standard including the column modification factors, factored compressive resistance, and final design ratio.
在上一篇文章中介绍了按照规范 DIN EN 1991-4 对筒仓施加荷载。 Am Beispiel eines freistehenden zylindrischen Silos mit einem konischen Trichter für Zement werden die Fülllasten auf den Trichter berechnet.
对于公路桥梁上的荷载作用,除了欧洲规范 EN 1990 中规定的的基本组合规则外,还必须遵守欧洲规范 EN 1991‑2 中规定的组合条件。 为此,RFEM 和 RSTAB 提供了自动创建组合功能,在“基本数据”对话框中可以激活该功能,并且选择欧洲规范 EN 1990 + EN 1991‑2。 在选择了相应国家附录后,相关的分项系数和组合系数被自动选取。