In RFEM 6, it is possible to define line welds on lines between surfaces and calculate the weld stresses using the Stress-Strain Analysis add-on. Questo articolo ti mostrerà come farlo.
Utilizzando il modulo aggiuntivo RF-STEEL AISC, è possibile verificare aste in acciaio secondo la norma AISC 360-16. The following article will compare the results between calculating lateral torsional buckling according to Chapter F and Eigenvalue Analysis.
Using the RF-TIMBER CSA module, timber beam design is possible according to the CSA O86-14 standard. Accurately calculating timber member bending resistance and adjustment factors is important for safety considerations and design. The following article will verify the factored bending moment resistance in the RFEM add-on module RF-TIMBER CSA using step-by-step analytical equations as per the CSA O86-14 standard including the bending modification factors, factored bending moment resistance, and final design ratio.
Quando si tratta di carichi del vento su strutture tipo edifici secondo ASCE 7, è possibile trovare numerose risorse per integrare le norme di progettazione e aiutare gli ingegneri con questa applicazione di carico laterale. However, engineers may find it more difficult to find similar resources for wind loading on non-building type structures. This article will examine the steps to calculate and apply wind loads as per ASCE 7-16 on a circular reinforced concrete tank with a dome roof.